Wiki » Historie » Revision 7
Revision 6 (Maximilian Seesslen, 12.11.2026 13:27) → Revision 7/8 (Maximilian Seesslen, 12.11.2026 13:47)
h1. Wiki
* 2 x CAN 2xCAN
* 2 x UART 2xUART
* Connect DAC to ADC.
* 2 further ADC inputs with different resistor dividers.
* Can even test debouncing; PWM to GPIO Input
* Test slope counter, Hz etc.
* Program internal flash
* Verify CRC calculation
* Any present SPI flash
* Any present I2C flash
* Compare systimer with RTC
* Test some patterns in UID
* UCPD test platform
* ADC fuer USBCPD
* HSE 8Mhz for USB
* Event-loop LED
* USB to I2C adapter
Cheapest would be:
* STM32G0B1CBU6; UFQFPN48; 128 Kbytes flash; 2048 erase page
* USBLC6-2SC6
* USB 22 Ohm in reihe
* CC1/CC2 5K1 Ohm gegen GND
Connections:
* Debug
* USB-C; FRSTX, CC1, CC2 (Fast Role Swap Transmit)
* PWM-LED + 5V output like CANIO
* I2C like CANIO
* CAN-Bus x 2, via solder-bridges
* 3V power output to supply test ICs
Other usefull function?
* CANIO as super big; RGB-LED controller
* PEAK Klon / USB-CAN Adapter
* 1,8V; Transceiver benoetigen 2V signale
* 2 x CAN 2xCAN
* 2 x UART 2xUART
* Connect DAC to ADC.
* 2 further ADC inputs with different resistor dividers.
* Can even test debouncing; PWM to GPIO Input
* Test slope counter, Hz etc.
* Program internal flash
* Verify CRC calculation
* Any present SPI flash
* Any present I2C flash
* Compare systimer with RTC
* Test some patterns in UID
* UCPD test platform
* ADC fuer USBCPD
* HSE 8Mhz for USB
* Event-loop LED
* USB to I2C adapter
Cheapest would be:
* STM32G0B1CBU6; UFQFPN48; 128 Kbytes flash; 2048 erase page
* USBLC6-2SC6
* USB 22 Ohm in reihe
* CC1/CC2 5K1 Ohm gegen GND
Connections:
* Debug
* USB-C; FRSTX, CC1, CC2 (Fast Role Swap Transmit)
* PWM-LED + 5V output like CANIO
* I2C like CANIO
* CAN-Bus x 2, via solder-bridges
* 3V power output to supply test ICs
Other usefull function?
* CANIO as super big; RGB-LED controller
* PEAK Klon / USB-CAN Adapter
* 1,8V; Transceiver benoetigen 2V signale