Roadmap¶

Ongoing¶

• Further Miniminutniks; v0.2.x; UART works at least in debug mode.
• Candisplay (i finally need light switches)
• Kastella (i need plants)
• Isoler; small dc/dc adapter, 2 LEDs
  • Test it on breadboard first
  • When it works: small cable adapter.
  • https://www.reichelt.de/dc-dc-wandler-am1p-z-1-w-5-v-200-ma-dil-8-sim1-0505s-dil8-p35039.html?search=sim1-0505
  • https://www.reichelt.de/dc-dc-wandler-tea-1-1-w-4-5-5-5-5-0-vdc-sil-4-tea-1-0505-p288651.html

To be started¶

• CANIO L
• Lighttimer/Switchbox
  • CANIO-L
• Lichtwecker
  • CANIO-L CANSwitch
• Canbridge
• Meteor; The BME680 has an accurracy of 0.5°C typical. So an additional more precice temperature sensor would be nice
  • ordered TMP117, +-0.1°C at –20°C to 50°C; total operation range: –55°C to 150°C
• CANSpeaker; I have these bigger smd speakers. CANDisplay is not very loud.
• Sensemux
  • verificate some stuff. CANSpeaker, Sensors, alarm-clock, plant-lamp
• eInk Minutnik
  • WSH-12561; 37,32x31,8;
  • AKKU 31063 (Garmin Fenix 3) 300mAh; 300 mAh; 31,6 x 24,8 x 4,3
  • Pixel-data is 5KB ((200*200)/8); need bigger MCU; but the STM32L433CCU6 i have is too much
  • STM32L151C6U6A waers eigentlich. USB, 128KB Flash, 32KB SRAM, EEPROM 32KB Flash, 10KB RAM, hat USB
  • STM32L051C8T6; no USB
• CANControl, Is this really needed
  • Controller with RTC, automatic on/off of CANSwitches
  • Controlls Kastella

(nearly) Finished¶

• Amp
• Miniminutnik
• CANIO (S)
• Temprec
• Slonce I