Hardware » CANBuz

h1. Eval

CANDis is quite silent.

CANBuz probably will have same issues. Need to test capacitors.

F=As/V

qalc 0,000022*3 = 0,000066 = 0,066mAs

Ich hab doch noch grosse 

Is it the power regulator/LDO? What did i solder?

h2. Parts

* LM386; "DS":https://www.ti.com/lit/ds/symlink/lm386.pdf ; page 10

* LM4861 M; 1,39€

** can be driven @5V; not sure if V+ has to be 3v/2 or 5v/2 ?

** Shutdown: power output off on logic high

h2. Amp

"lm4871":https://www.ti.com/lit/ds/symlink/lm4871.pdf

h2. MCU

* STM32F042G4U6; UFQFPN28; 16KB; hab ich noch 17

* Get rid of an STM32F072 in order to have DAC?

* STM32G431KBU6

** SAI; FPU

** 5,87€

* STM32F072CBT6

** LQFP-48

** 2,40 €

* STM32F103CBT6

** 2,12 €

* STM32F303C6U6A

h2. DAC

* Maybe later; SAI would be more interesting. DAC for testing DMA.

* 44,100 Hz

* Would require SPI flash for recorded sound

* Adjustable volume

* Solderbridge for fallback

h2. Flash

DAC-DMA already works for sinewave (copied due to speed). So FLash might be cool for sound samples.

CD: 44100 samples / sec; 

44100*2*2 = 176'400 Bytes / s; Flash readout has to be a little bit faster for the overhead.

1MB would play around 6 seconds. 2MB / 16Mbit would be ok.

32Mb/4MB available for 1,94€; 100Mhz

STM32F303 has max SPI rate 18Mbits/s or 2,25MB/s

h2. USB

USB would be nice for writing sound samples to flash. But this might be a nice candidate for writing flash images over CAN.

Although it might take very long time.